SSH EN 61347-1:2015

Pajisje kontrolli për llamba - Pjesa 1: Kërkesa të përgjithshme dhe sigurie

Lamp controlgear - Part 1: General and safety requirements

Scope

<span style='color:red'>NEW!</span> IEC 61347-1:2015 is available as <a href="http://webstore.iec.ch/webstore/webstore.nsf/Artnum_PK/99999341135?opendocument">IEC Standards+ 61347-1:2015 which contains the International Standard and its Redline version, showing all changes of the technical content compared to the previous edition.


IEC 61347-1:2015 specifies general and safety requirements for lamp controlgear for use on d.c. supplies up to 250 V and/or a.c. supplies up to 1 000 V at 50 Hz or 60 Hz. This third edition cancels and replaces the second edition published in 2007, Amendment 1:2010 and Amendment 2:2012. This edition constitutes a technical revision.
This edition includes the following significant technical changes with respect to the previous edition:

a) additional marking requirements;

b) additional requirements for creepage distances and clearances:

- for working voltages with operating frequencies up to 30 kHz;

- for working voltages with higher operating frequencies than 30 kHz;

- for impulse and resonance voltages ignition;

- for basic, supplementary and reinforced insulation;

- for insulation between circuits;

- for coated or potted controlgear;

c) modification of definition of ELV and FELV;

d) modification of schematic drawing, showing the different controlgear classification and insulation requirements;

e) scope extension;

f) new Annex A: test to establish whether a conductive part is a live part which may cause an electric shock;

g) new Annex M: creepage distances and clearances for controlgear where a higher degree of availability (impulse withstand category III) may be requested;

h) new Annex Q: example for Up calculation;

i) new Annex P: creepage distances and clearances and distance through isolation (DTI) for lamp controlgear which are protected against pollution by the use of coating or potting;

j) new Annex R: concept of creepage distances and clearances.

Related directives

Directives related to this standards.