DPS
Drejtoria e Përgjithshme e Standardizimit
Tel/Cel: +355 4 222 62 55
E-mail: info@dps.gov.al
Adresa: Rr.: "Reshit Collaku", (pranë ILDKPKI, kati VI), Kutia Postare 98, Tiranë - Shqipëri
Main menu

ISO 19880-5:2019

Gaseous hydrogen — Fuelling stations — Part 5: Dispenser hoses and hose assemblies
18 nën 2019

General information

90.92     30 gush 2023

ISO

ISO/TC 197

International Standard

43.060.40     71.100.20  

anglisht  

Buying

Publikuar

Language in which you want to receive the document.

Scope

This document specifies the requirements for wire or textile reinforced hoses and hose assemblies suitable for dispensing hydrogen up to 70 MPa nominal working pressure, in the operating temperature range of −40 °C to 65 °C.
This document contains safety requirements for material, design, manufacture and testing of gaseous hydrogen hose and hose assemblies for hydrogen fuelling stations.
Hoses and hose assemblies excluded from the scope of this document are the following:
1) those used as part of a vehicle high pressure on-board fuel storage system,
2) those used as part of a vehicle low pressure fuel delivery system, and
3) flexible metal hoses.
NOTE 1 This document was developed primarily for hoses and hose assemblies for dispensing high pressure hydrogen from refuelling dispensers to hydrogen vehicles. Requirements for hoses used to deliver hydrogen from a transportable vessel (e.g. trailer) into a buffer storage of a station are addressed in ISO 16964.
NOTE 2 Hose assemblies include the hose with connectors on each end (see Figure 1). Each connector has two basic functional elements that are addressed as described below:
1) Coupling to hose. This function is defined by requirements and verified (along with the hose itself) by performance-based tests in this document.
2) Fitting for transition and connection to the piping system or equipment. This function is addressed by reference to appropriate hydrogen equipment standards and piping codes.

Life cycle

NOW

PUBLISHED
ISO 19880-5:2019
90.92 Standard to be revised
30 gush 2023

CORRIGENDA / AMENDMENTS

ABANDON
ISO 19880-5:2019/DAmd 1

REVISED BY

ABANDON
ISO/WD 19880-5

IN_DEVELOPMENT
ISO 19880-5