SSH EN 302 065-1 V1.3.1:2014

Electromagnetic compatibility and Radio spectrum Matters (ERM); Short Range Devices (SRD) using Ultra Wide Band technology (UWB); Harmonized EN covering the essential requirements of article 3.2 of the R&TTE Directive; Part 1: Requirements for Generic UWB applications

Scope

The present document applies to transceivers, transmitters and receivers utilizing Ultra WideBand (UWB) technologies
and used for short range applications.
The present document applies to impulse, modified impulse and RF carrier based UWB communication technologies.
The present document applies to fixed (indoor only), mobile or portable applications, e.g.:
• stand-alone radio equipment with or without its own control provisions;
• plug-in radio devices intended for use with, or within, a variety of host systems, e.g. personal computers,
hand-held terminals, etc.;
• plug-in radio devices intended for use within combined equipment, e.g. cable modems, set-top boxes, access
points, etc.;
• combined equipment or a combination of a plug-in radio device and a specific type of host equipment.
NOTE: As per the ECC/DEC/(06)04 [i.2], CEPT report 45 [i.17] and Commission Decision 2007/131/EC [i.8]
and its amendment the UWB transmitter equipment conforming to the present document is not to be
installed at a fixed outdoor location, for use in flying models, aircraft and other forms of aviation. The
present document applies to UWB equipment with an output connection used with a dedicated antenna or
UWB equipment with an integral antenna.
Equipment covered by the present document operates in accordance with ECC/DEC(06)04 [i.2] "The harmonised
conditions for devices using Ultra-Wideband (UWB) technology in bands below 10.6 GHz".
These radio equipment types are capable of operating in all or part of the frequency bands given in Table 1.
Table 1: Operating frequency bands
Operating frequency bands
Transmit 3,1 GHz to 4,8 GHz
Receive 3,1 GHz to 4,8 GHz
Transmit 6,0 GHz to 9 GHz
Receive 6,0 GHz to 9 GHz
NOTE: The UWB radio device can also operate outside of the operating frequency bands shown in the present table
provided that the limits in clause 4.2.3, Table 2 are met.
The present document does not apply to radio equipment for which a specific Harmonized EN applies as such
Harmonized EN may specify additional EN requirements relevant to the presumption of conformity under article 3.2 of
the R&TTE Directive [i.15].
ETSI
8 ETSI EN