Publikuar
ISO/TS 10303-1828:2019 specifies the application module for
Wiring harness assembly design.
The following are within the scope of
ISO/TS 10303-1828:2019:
electrical definition of a wiring harness;
wire-list for an wiring harness assembly, consisting of:
wires and cables;
terminal lug;
terminal block;
electrically non conductive through termination;
wire cap;
single and multi pin connector contact;
splice definitions within the harness assembly;
electrical shielding definition in the assembly.
component-list for an wiring harness assembly, consisting of:
connector and associated material;
terminal lug;
terminal block;
electrically non conductive through termination;
wire cap;
single and multi pin connector contact;
splice definitions within the harness assembly;
electrical shielding definition in the assembly;
tape marking.
modifications made to the cables and wires to be used in the harness;
assembly joints, each of which specify the mechanical connection between two terminals;
requirement allocation from the physical connectivity definition to the implementing item in the wire list;
assembly_joint that reference an external item;
segment topology of an electrical harness;
cross section structure of harness segments;
marking of harness components and topology segments;
protection of harness segments including:
grommet;
retention clamps;
sleeving;
overall shielding for one or more harness segments.
items within the scope of application module Wire and cable design connectivity, ISO/TS 10303-1845;
items within the scope of application module Extruded structure cross section, ISO/TS 10303-1827;
items within the scope of application module Edge based topological representation with length, ISO/TS 10303-1830.
Revises
ISO/TS 10303-1828:2018
PUBLISHED
ISO/TS 10303-1828:2019
60.60
Standard published
15 nën 2019
Only informative sections of projects are publicly available. To view the full content, you will need to members of the committee. If you are a member, please log in to your account by clicking on the "Log in" button.