ISO/TS 10303-1828:2019

Industrial automation systems and integration — Product data representation and exchange — Part 1828: Application module: Wiring harness assembly design

Scope

ISO/TS 10303-1828:2019 specifies the application module for
Wiring harness assembly design.



The following are within the scope of
ISO/TS 10303-1828:2019:



electrical definition of a wiring harness;
wire-list for an wiring harness assembly, consisting of:

wires and cables;terminal lug;terminal block;electrically non conductive through termination;wire cap;single and multi pin connector contact;splice definitions within the harness assembly;electrical shielding definition in the assembly.


component-list for an wiring harness assembly, consisting of:

connector and associated material;terminal lug;terminal block;electrically non conductive through termination;wire cap;single and multi pin connector contact;splice definitions within the harness assembly;electrical shielding definition in the assembly;tape marking.


modifications made to the cables and wires to be used in the harness;
assembly joints, each of which specify the mechanical connection between two terminals;
requirement allocation from the physical connectivity definition to the implementing item in the wire list;
assembly_joint that reference an external item;
segment topology of an electrical harness;
cross section structure of harness segments;
marking of harness components and topology segments;
protection of harness segments including:

grommet;retention clamps;sleeving;overall shielding for one or more harness segments.


items within the scope of application module Wire and cable design connectivity, ISO/TS 10303-1845;
items within the scope of application module Extruded structure cross section, ISO/TS 10303-1827;
items within the scope of application module Edge based topological representation with length, ISO/TS 10303-1830.