Projects

Packaging — Steel drums — Part 1: Removable head (open head) drums with a minimum total capacity of 208 l, 210 l and 216,5 l

90.93 Standard confirmed

Packaging — Steel drums — Part 2: Non-removable head (tight head) drums with a minimum total capacity of 212 l, 216,5 l and 230 l

90.93 Standard confirmed

Packaging — Steel drums — Part 3: Inserted flange-type closure systems

60.60 Standard published

Ophthalmic instruments — Endoilluminators — Fundamental requirements and test methods for optical radiation safety

90.92 Standard to be revised

Animal and vegetable fats and oils — Determination of polycyclic aromatic hydrocarbons

90.93 Standard confirmed

Paper and board — Determination of z-directional tensile strength

90.93 Standard confirmed

Hygrothermal performance of building equipment and industrial installations — Calculation of water vapour diffusion — Cold pipe insulation systems

90.60 Close of review

Medical infusion equipment — Plastics caps with inserted elastomeric liner for containers manufactured by the blow-fill-seal (BFS) process

90.93 Standard confirmed

Tea — Determination of water-soluble ash and water-insoluble ash

90.93 Standard confirmed

Steel gate, globe and check valves for sizes DN 100 and smaller, for the petroleum and natural gas industries

90.93 Standard confirmed

Road vehicles — Alarm systems for buses and commercial vehicles of maximum authorized total mass greater than 3,5 t

90.93 Standard confirmed

Road vehicles — Diagnostic communication over Controller Area Network (DoCAN) — Part 2: Transport protocol and network layer services

90.92 Standard to be revised

Road vehicles — Diagnostic communication over Controller Area Network (DoCAN) — Part 4: Requirements for emissions-related systems

60.60 Standard published

Road vehicles — Diagnostic communication over Controller Area Network (DoCAN) — Part 5: Specification for an in-vehicle network connected to the diagnostic link connector

60.60 Standard published

Road vehicles — Pedestrian protection — Targets for the assessment of the biofidelity of pedestrian-leg test devices

60.60 Standard published

Workplace atmospheres — Controlling and characterizing uncertainty in weighing collected aerosols

90.93 Standard confirmed

Measurement of liquid velocity in open channels — Design, selection and use of electromagnetic current meters

90.93 Standard confirmed

Hydrometry — Guidelines for the application of acoustic velocity meters using the Doppler and echo correlation methods

90.20 Standard under periodical review