Use the form below to find the searched projects. Enter your criteria for searching (single or in combination) in the fields below and press the button “Search”.
Health informatics — System of concepts to support continuity of care
90.92 Standard to be revised
Bonded abrasive products — Limit deviations and run-out tolerances
90.93 Standard confirmed
Lubricated metal-powder mixes — Determination of lubricant content — Soxhlet extraction method
90.93 Standard confirmed
Metallic powders — Test method for the determination of non-metallic inclusions in metal powders using a powder-forged specimen
60.60 Standard published
Diesel engines — Fuel injection pumps and fuel injector low-pressure connections — Part 1: Threaded connections
90.20 Standard under periodical review
Diesel engines — Fuel injection pumps and fuel injector low-pressure connections — Part 2: Non-threaded (push-on) connections
60.60 Standard published
Plastics pipes and fittings — Automatic recognition systems for electrofusion joints
90.93 Standard confirmed
Plastics pipes and fittings — Automatic recognition systems for electrofusion joints — Technical Corrigendum 1
60.60 Standard published
Plastics piping systems — Test method for the resistance of plastic pipe/pipe or pipe/fitting assemblies to tensile loading
90.93 Standard confirmed
Polyethylene (PE) pipes and fittings — Determination of the tensile strength and failure mode of test pieces from a butt-fused joint
90.93 Standard confirmed
Polyethylene (PE) pipes and fittings — Determination of the tensile strength and failure mode of test pieces from a butt-fused joint — Amendment 1
60.60 Standard published
Plastics pipes and fittings — Peel decohesion test for polyethylene (PE) electrofusion assemblies of nominal outside diameter greater than or equal to 90 mm
60.60 Standard published
Plastics pipes and fittings — Crushing decohesion test for polyethylene (PE) electrofusion assemblies
90.93 Standard confirmed
Plastics pipes and fittings — Crushing decohesion test for polyethylene (PE) electrofusion assemblies — Amendment 1
60.60 Standard published
Plastics pipes and fittings — Decohesion test of polyethylene (PE) saddle fusion joints — Evaluation of ductility of fusion joint interface by tear test
60.60 Standard published
Plastics pipes and fittings — Polyethylene (PE) tapping tees — Test method for impact resistance
90.93 Standard confirmed
Air quality — Determination of ozone in ambient air — Ultraviolet photometric method
90.93 Standard confirmed
English