SSH EN 12285-2:2006

Workshop fabricated steel tanks - Part 2: Horizontal cylindrical single skin and double skin tanks for the aboveground storage of flammable and non-flammable water polluting liquids

Scope

This document specifies the requirements for metallic shop fabricated cylindrical, horizontal steel tanks, single and double skin for the aboveground storage of water polluting liquids (both flammable and non-flammable) within the following limits:
- from 800 mm up to 3 000 mm nominal diameter and,
- up to a maximum overall length of 6 times the nominal diameter and,
- for liquids with a maximum density of up to 1,9 kg/l and,
- with an operating pressure (Po) of maximum 1,5 bar (abs.) and,
- where double skin tanks with a vacuum leak detection system are used the cinematic viscosity of the stored media shall not exceed 5 ´ 10-3 m2/s.
This document is applicable for normal ambient temperature conditions (- 20 °C to + 50 °C). Where temperatures are outside this range, additional requirements need to be taken into account.
This document is not applicable for the storage of liquids having dangerous good classes listed in Table 1 because of the special dangers involved.
Table 1 - List of dangerous goods the storage of which are not covered by this document
UN-classification Storage media
Class 1 Explosives
Class 4.2 Substances liable to spontaneous combustion
Class 4.3 Substances which in contact with water emit flammable gases
Class 5.2 Organic peroxides
Class 6.2 Infectious substances
Class 7 Radioactive material, hydrocyanic or hydrocyanic solvent liquids, metalcarbonyls, hydrofluoracid, bromide liquids

NOTE The classifications referred to are those adopted by the United Nations Committee of Experts on the Transport of Dangerous Goods (not to be interpreted as tank classes described in 3.1.4).
This document does not cover the installation of tanks which might be subject to local regulations involving pollution control.

Related directives

Directives related to this standards.