ISO/TS 10303-1828 specifies the application module for Wiring harness assembly design.
The following are within the scope of ISO/TS 10303-1828:
electrical definition of a wiring harness;
wire-list for an wiring harness assembly, consisting of:
wires and cables;
terminal lug;
terminal block;
electrically non conductive through termination;
wire cap;
single and multi pin connector contact;
splice definitions within the harness assembly;
electrical shielding definition in the assembly.
component-list for an wiring harness assembly, consisting of:
connector and associated material;
terminal lug;
terminal block;
electrically non conductive through termination;
wire cap;
single and multi pin connector contact;
splice definitions within the harness assembly;
electrical shielding definition in the assembly;
tape marking.
modifications made to the cables and wires to be used in the harness;
assembly joints, each of which specify the mechanical connection between two terminals;
requirement allocation from the physical connectivity definition to the implementing item in the wire list;
assembly_joint that reference an external item;
segment topology of an electrical harness;
cross section structure of harness segments;
marking of harness components and topology segments;
protection of harness segments including:
grommet;
retention clamps;
sleeving;
overall shielding for one or more harness segments.
items within the scope of application module Wire and cable design connectivity, ISO/TS 10303-1845;
items within the scope of application module Extruded structure cross section, ISO/TS 10303-1827;
items within the scope of application module Edge based topological representation with length, ISO/TS 10303-1830.
Revises
ISO/TS 10303-1828:2022
PUBLISHED
ISO/TS 10303-1828:2024
60.60
Standard published
3 sht 2024
Only informative sections of projects are publicly available. To view the full content, you will need to members of the committee. If you are a member, please log in to your account by clicking on the "Log in" button.