ISO/TS 10303-1647:2014-02 specifies the application module for
Assembly physical interface requirement.
The following are within the scope of
ISO/TS 10303-1647:2014-02:
the representation of the information needed to describe the manner by which an electronic assembly shall mechanically
interface to the next higher assembly. The type of mating connector and its location relative to the electronic assembly are
provided as a design requirement, that must be satisfied in the design.
The module includes representation of the information needed to describe a physical layer of a communication protocol at
a connector interface level.
mating connector location;design volume description;physical protocol layer description including connector pinout mapping to signal names;
Revises
ISO/TS 10303-1647:2010
WITHDRAWN
ISO/TS 10303-1647:2014
95.99
Withdrawal of Standard
15 nën 2019
PUBLISHED
ISO/TS 10303-1647:2019
Only informative sections of projects are publicly available. To view the full content, you will need to members of the committee. If you are a member, please log in to your account by clicking on the "Log in" button.