ISO/TS 10303-1647:2006 specifies the application module for
Assembly physical interface requirement.
ISO/TS 10303-1647:2006 deals with the representation of the information needed to describe the manner by which an electronic assembly shall mechanically
interface to the next higher assembly. The type of mating connector and its location relative to the electronic assembly are
provided as a design requirement that must be satisfied in the design.
ISO/TS 10303-1647:2006 includes representation of the information needed to describe a physical layer of a communication protocol at
a connector interface level.
The following are within the scope of
ISO/TS 10303-1647:2006:
mating connector location;design volume description;physical protocol layer description including connector pinout mapping to signal names.
WITHDRAWN
ISO/TS 10303-1647:2006
95.99
Withdrawal of Standard
May 18, 2010
WITHDRAWN
ISO/TS 10303-1647:2010
Only informative sections of projects are publicly available. To view the full content, you will need to members of the committee. If you are a member, please log in to your account by clicking on the "Log in" button.
Shqip