IEC 60335-2-32:2024 ED6

Household and similar electrical appliances - Safety - Part 2-32: Particular requirements for massage appliances

Scope

IEC 60335-2-32:2024 deals with the safety of electric massage appliances for household and similar purposes, their rated voltage being not more than 250 V for single phase appliances and 480 V for other appliances including direct current (DC) supplied appliances and battery-operated appliances.
Examples of appliances within the scope of this standard are
- foot massagers;
- water filled foot massagers;
- hand-held massagers;
- massage beds;
- massage belts;
- massage chairs;
- massage pads.
Appliances not intended for normal household use but that nevertheless can be a source of danger to the public, such as appliances intended to be used by laypersons in shops, in light industry and on farms, are within the scope of this standard.
As far as is practicable, this standard deals with the common hazards presented by appliances that are encountered by all persons in and around the home.
Attention is drawn to the fact that
- for appliances intended to be used in vehicles or on board ships or aircraft, additional requirements can be necessary;
- in many countries additional requirements are specified by the national health authorities, the national authorities responsible for the protection of labour and similar authorities.
This standard does not apply to
- appliances intended exclusively for industrial purposes;
- appliances intended to be used in locations where special conditions prevail, such as the presence of a corrosive or explosive atmosphere (dust, vapour or gas);
- electric foot care appliances that do not contain motors and other electric appliances for the care of skin or hair (IEC 60335-2-23);
- electric appliances for beauty care of persons and intended for household, commercial and similar purposes (IEC 60335-2-115).
This sixth edition cancels and replaces the fifth edition published in 2019. This edition constitutes a technical revision.
This edition includes the following significant technical changes with respect to the previous edition:
a) alignment with IEC 60335-1:2020;
b) conversion of some notes to normative text (Clause 1);
c) application of test probe 19 (8.1.1, 20.2, B.22.3, B.22.4).
This part 2 is to be used in conjunction with the latest edition of IEC 60335-1 and its amendments unless that edition precludes it; in that case, the latest edition that does not preclude it is used. It was established on the basis of the sixth edition (2020) of that standard.