IEC TS 63527 ED1

Safe management and operation of electrical installations

Scope

IEC TS 63527:2025 (EN) is applicable to the safe management and operation of and work activity on, with, or near electrical installations operating at voltage levels from and including extra-low voltage up to and including high voltage.
This latter term includes those levels commonly referred to as medium and extra-high voltage.
These electrical installations are designed for the generation, transmission, conversion, distribution and use of electrical power. Some of these electrical installations are permanent and fixed, such as a distribution installation in a factory or office complex, others are temporary, such as on construction sites, and others are mobile or capable of being moved either whilst energized or whilst not energized nor charged. Examples are electrically driven excavating machines in quarries or open-cast coal sites.
This document sets out the requirements for the safe management and operation of and work activity on, with, or near these electrical installations. The requirements apply to all operational, working and maintenance procedures. They apply to all non-electrical work such as building work near to overhead lines or underground cables as well as electrical work , when there is a risk of electrical danger.
This document does not apply to ordinary persons when using installations and equipment, provided that the installations and equipment comply with relevant standards and are designed and installed for use by ordinary persons.
This document has not been developed specifically to apply to the electrical installations listed below. However, if there are no other rules or procedures, the principles of this document could be applied to them:
– on any aircraft and hovercraft moving under its own power, (international aviation laws can apply);
– on any sea going ship moving under its own power, or under the direction of the master, (international marine laws can apply);
– electronic telecommunications and information systems;
– electronic instrumentation, control and automation systems;
– at coal or other mines;
– on off-shore installations (international marine laws can apply);
– on vehicles;
– on electric traction systems;
–on experimental electrical research work.