SSH EN 13074-1:2019

Bitumen and bituminous binders - Recovery of binder from bituminous emulsion or cut-back or fluxed bituminous binders - Part 1: Recovery by evaporation

Scope

This European Standard specifies a method for the recovery of binder from a bituminous emulsion or from a cut-back or fluxed bitumen after conditioning at ambient temperature for 24 h followed by 24 h at 50 °C, in such a way that will enable further testing with minimum changes of the binder characteristics.
It applies to all types of bituminous emulsions, modified with polymers or non-modified, as well as to all types of cut-back and fluxed bitumen, both modified with polymers and non-modified.
For cut-back and fluxed bituminous binders, this test method is only an intermediate step and should be followed by the stabilisation procedure specified by EN 13074-2. Direct testing of the recovered binder is however used to evaluate the setting ability of fluxed bituminous binders made with vegetal fluxes.
NOTE The recovered binder is not necessarily identical to the initial binder.
WARNING - The use of this document may involve hazardous materials, operations and equipment. This document does not purport to address all of the safety problems associated with its use. The hazards associated with the use of this method have been assessed using cut-back bitumen containing 10 % kerosene and 90 % 160/220 penetration grade bitumen and were found low enough to be acceptable. However it is the responsibility of the user of this document to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.