SSH EN 1591-1:2006

Flanges and their joints - Design rules for gasketed circular flange connections - Part 1: Calculation method

Scope

1.1 General
This European Standard defines a Calculation method for bolted, gasketed, circular flange joints. Its purpose is to ensure structural integrity and control of leaktightness. ENV 1591-2 gives values for gasket properties which can be used in the Calculation method.
1.2 Requirement for use of the Calculation method
Where permitted, the Calculation method is an alternative to design validation by other means e.g.
special testing;
proven practice;
use of standard flanges within permitted conditions.
1.3 -Validity
1.3.1 Geometry
The Calculation method is applicable to the configurations having:
flanges whose section is given or may be assimilated to those given in Figures 4 to 12;
four or more identical bolts uniformly distributed;
gasket whose section and configuration after loading can be assimilated by one of those given in Figure 3;
flange dimension which meet the following conditions:
a) 0,2 bF/eF 5,0; 0,2 bL/eL 5,0
b)
e sub FUNC F ~>=~max ~LEFT LBRACE e sub 2;~ d sub { FUNC B0};~ p sub FUNC B ~ × ~ NROOT 3 {(0,01...0,10) ~ × ~ p sub FUNC B / b sub FUNC F } RIGHT RBRACE
c) cos s 1/(1 + 0,01 ds/es)
NOTE 1 For explanations of symbols see clause 3.
NOTE 2 The condition bF/eF 5,0 need not to be met for collar in combination with loose flange.
NOTE 3 The condition
is for limitation of non-uniformity of gasket pressure due to spacing of bolts. The values 0,01 and 0,10 are to be applied for soft (non-metallic) and hard (metallic) gaskets respectively. A more precise criterion is given in annex A.
NOTE 4 Attention may need to be given to the effects of tolerances and corrosion on dimensions; reference should be made to other codes under which the calculation is made, for example values are given in EN 13445 and EN 13480.

Related directives

Directives related to this standards.